Instruction manual

DATALOGIC

CODE SELECTION

issue identical codes = enable

enabled codes

Standard Code 39: no check digit control, variable code length;

EAN 8/EAN 13 / UPC A/UPC E without ADD ON: UPCE expansion disabled

Interleaved 2/5: check digit control and transmission, variable code length

Code 128: variable code length

PDF417

Datamatrix

: rectangular, normal and inverted, variable code length

disabled codes

Code 32, Codabar, Code 93, EAN 128, Aztec, GS1 DataBar™, Micro

PDF417, Postal Codes, Maxicode, Composite Codes

READING PARAMETERS

trigger type normal, trigger level mode, flash on = 2 sec, flash off = 2 sec,

beeper tone = tone 1, beeper volume = high, beeper duration = 50 ms, user

defined beeper = tone 1, user defined beeper volume = high, user defined

beeper duration = 100 ms, code per scan = one code per scan, read per

cycle = one read per cycle, scan timeout = 5 sec, central code transmission

enabled, order by code length disabled, order by code symbology disabled,

autoscan mode disabled, autoscan aiming system enabled, autoscan

hardware trigger enabled, autoscan illumination system disabled, stand

autoscan mode = normal, aiming system delay = disabled, good read spot =

short, safety time = 500 ms

IMAGE FORMATTING

Image Preset 1, 2, 3, 4

image format = JPEG, resolution = full (1280 x 1024), set JPEG quality

factor = 50, brightness = 0%, contrast = 0%, color depth = 256 gray level.