manual

PowerScan® M8500 Configuration
14 PowerScan® M8500
Using Multiple Readers with Same Cradle
If you want to use several readers associated with the same cradle, you must first
Bind the cradle with one of the readers (see previously described configuration
procedure).
Successive readers can be associated with the same cradle by following the configu-
ration procedure substituting the Bind command with Join.
END of procedure.
PowerScan
®
M8500/STAR-MODEM™ Stand Alone Setup
To configure a PowerScan® M8500 reader to communicate with STAR-
Modem™ in Stand Alone Mode, follow the "PowerScan® M8500/BC-80X0
Stand Alone Setup" procedure substituting steps 5 and 6 with those below:
END of procedure. YOUR READER IS NOW READY TO READ CODES.
7. Join
The green LED on the PowerScan
®
M8500 will blink: the reader is ready to be
positioned onto the cradle. Complete step 8.
CAUTION
All readers associated with the same cradle must have different
addresses.
6. STAR-Modem™ Address
Read the code above and the four-digit address
of the STAR-Modem™.
7. Exit and Save Configuration