manual

Default Configuration

18 PowerScan® M8500

Default Configuration

DATA FORMAT – Symbology Dependent Parameters

symbology specific format = select all, no headers, no terminators, symbology character

substitution disabled, symbology character deletion disabled

DATA FORMAT – Concatenation

Concatenation disabled, 2 EAN/UPC codes concatenated, Set First Concatenated Code

Length 000 = any length, Set Second Concatenated Code Length 000 = any length, Set

Third Concatenated Code Length 000 = any length, Set Fourth Concatenated Code Length

000 = any length, Concatenation with Intercode Delay disabled, Concatenation Timeout 10

seconds, Concatenation Failure Transmission = Tx codes causing failure, Transmission after

Timeout = No code transmission, Concatenation Result Code ID = No code Identifier

ADVANCED FORMATTING PARAMETERS

format disabled

CAMERA CONTROL

exposure mode = automatic, based on entire image

CODE SELECTION

issue identical codes = enable

enabled codes

Standard Code 39: no check digit control, variable code length;

EAN 8/EAN 13 / UPC A/UPC E without ADD ON

: UPCE expansion disabled

Code 128

: variable code length

PDF417

Datamatrix: rectangular, normal and inverted, variable code length

disabled codes

Code 32, Interleaved 2/5, Codabar, Code 93, EAN 128, GS1 DataBar™, Micro PDF417, Postal

Codes, Maxicode, Composite Codes

Aztec, microQR, IMB.

READING PARAMETERS

trigger type normal, trigger level mode, flash on = 2 sec, flash off = 2 sec, beeper tone =

tone 1, beeper volume = high, beeper duration = 50 ms, user defined beeper = tone 1, user

defined beeper volume = high, user defined beeper duration = 100 ms, code per scan = one

code per scan, read per cycle = one read per cycle, scan timeout = 5 sec, central code

transmission = disabled, order by code length = disabled, order by code symbology =

disabled, autoscan mode = disabled, autoscan aiming system = enabled, autoscan

hardware trigger = enabled, autoscan illumination system = disabled, stand autoscan mode

= normal, aiming system delay = disabled, good read spot = short, safety time = 500 ms

RADIO PARAMETERS

radio protocol timeout = 2 seconds, power-off timeout = 4 hours, transmission mode =

one-way, beeper control for radio response = normal, single store = disabled, batch mode =

disabled, find me = enabled, radio RX timeout = disabled