Installation manual

vii
Disconnect the power supply when
opening the device during maintenance or
installation to avoid exposure to hazardous
laser light.
The laser diode used in this device is
classified as a class 3B laser product
according to EN 60825-1 regulations and
as a Class IIIb laser product according to
CDRH regulations.
Any violation of the optic parts in particular
can cause radiation up to the maximum
level of the laser diode (35 mW at 630 to
680 nm).
Warning and Device Class Labels
FCC COMPLIANCE
Modifications or changes to this equipment without the expressed written approval of
Datalogic could void the authority to use the equipment.
This device complies with PART 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference which may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
POWER SUPPLY
This product is intended to be installed by Qualified Personnel only.
This accessory device is intended to be supplied by a UL Listed or CSA Certified Power Unit
with «Class 2» or LPS power source, which supplies power directly to the scanner via the 25-
pin connector.
Phone: [phone] - Fax: [phone] - Web: www.ctiautomation.net - Email: [e-mail]