Product specifications

EAN UCC Composite
Product Reference Guide 279
EAN UCC Composite — continued
EAN UCC Composite Data Group Characters
Once you’ve pre-set your desired Data Group Characters
1
using the Data Group
Characters
feature found in Chapter 5, Data Editing, you can choose to output
up to two of those pre-sets whenever an EAN UCC Composite bar code is
scanned.
To set this feature:
1. Determine which Data Group pre-set(s) to output. You can select up to
two from the following:
Data Group 1 * Data Group 2 * Data Group 3 * Data Group 4
For example, your choice might be Data Group 2 only; Data Groups 1
and 3; Data Groups 3 and 4; or no Data Groups.
2. Scan the START bar code to place the imager in Programming Mode.
3. Scan the SET EAN UCC COMPOSITEDATA GROUP CHARAC-
TERS bar code.
4. Turn to
Appendix B, Alpha-Numeric Pad and scan the digits representing
the Data Group designation(s) chosen in the first step above. A digit of
value zero (0) selects “no group.” For example, scanning 3 and 0 would
output only the character(s) set for Data Group 3 whenever an EAN
UCC Composite bar code was scanned. Scanning digits 1 and 2 would
output both Data Groups 2 and 3. To select no Data Groups at all, scan
0, then 0 again.
5. Scan the SET bar code to accept the digits scanned.
6. Scan the END bar code to exit Programming Mode.
1. In that chapter, you can select which character(s) and position(s) to place Data Characters within
scanned data output.
NOTE
The options in this section set Data Group Characters
for the EAN UCC Composite symbology ONLY. If you
wish to enable this feature for additional symbologies,
turn to the options in the section specific to the other
symbology(s).