Product specifications

Bluetooth Features

292 QuickScan

QS6500/QS6500BT

Bluetooth Connectivity Mode

This feature allows the imager to be linked to any Bluetooth (BT) enabled

device which can accept such a connection with other devices. To implement

this mode, follow these instructions:

1. Place the imager in Programming Mode by scanning the START bar

code.

2. Scan the “Connect to a BT Device” bar code to put the imager in the

mode enabling a link to a device other than its own Base Station.

3. Scan the END bar code to exit Programming Mode.

4. Scan the “Begin Pin” bar code.

5. Set the four- to six-character PIN code assigned to the target Bluetooth

device using the bar codes available in

Appendix B, Alpha-Numeric Pad.

6. Scan the “Set” bar code.

7. Scan the “End Pin” bar code.

8. Use the software that drives the other BT device to scan for devices in the

area. The QS6500BT imager will be displayed as "Datalogic

handheld

scanner." Each BT device uses different methods to link, so you’ll need to

follow the instructions for the device being connected to.

1. Depending upon when your scanner was purchased, the display might read “PSC handheld scan-

ner.”

NOTE

The Serial Peripheral Protocol is the only inter-

face supported.