User manual

Getting Started

8 QuickScan

Lite QW2100

Hands Free Stand — continued

The holder cup can be positioned in any of the three angles shown in Figure 4. Grasp

the holder cup as indicated and rotate to the desired position.

Refer to Scan Mode on page 30 for information about programming the reader for use

with the stand.

Figure 4. Adjusting the Stand

This accessory can also be used as a holder to mount the reader on a wall or other vertical

position as shown in Figure 5.

Figure 5. Using the Wall Holder

Programming

The reader is typically factory-configured with a set of default features standard to the

interface type you ordered. After scanning the interface bar code from the

Interfaces sec-

tion, you can select other options and customize your reader through use of the instruc-

tions and programming bar codes available in the corresponding features section for your

interface and also the

Data Editing and Symbologies chapters of this manual.