User`s manual

x
QUICK START
Verify that Rhino™ and all the parts supplied with the equipment are present and intact when
opening the packaging.
Contact the nearest Datalogic distributor for further information.
Keep this package should it be necessary for expedition to technical assistance centre.
This section’s instructions are based on the assumption that your new system is pre-
configured and requires only accessory installation (e.g. external barcode scanner) and a
power source.
Use this guide as you would any other source book - reading portions to learn about the
RHINO™, and then referring to it when you need more information about a particular subject.
This guide takes you through installation and operation of the RHINO™.
In general, the sequence of events is:
1. Install Mounting Bracket on vehicle. (see chapter 2)
2. Secure RHINO™ in Mounting Bracket Assembly (see chapter 2 and following).
3. Connect power cable to the RHINO™ (see paragraph 2.6).
4. Connect vehicle power source to RHINO™ power cable (see paragraph 2.7).
5. Install accessories on RHINO™, e.g. scanner (see chapter 2.4, 2.5).
6. Secure cables to the RHINO™ with strain relief cable clamps (see chapter 2.5).
7. Turn RHINO™ on.
The RHINO™ should be mounted in an area in the vehicle where it:
• Does not obstruct the vehicle operator's vision or safe vehicle operation.
• Will be protected from rain or inclement weather.
• Will be protected from extremely high concentrations of dust or wind-blown debris.
• Can be easily accessed by an operator seated in the driver's seat.