User's Manual

Installation & Operation Manual V 1.0 12 (19)
The transponder is first visible when entering the magnetic field the first time and it is detected only
once without regards to the time spent in the field.
A chip having left the magnetic field can be read again only having spent an amount of time T outside
of it. If the time spent outside the magnetic field is less than T, the chip cannot be detected. The time
T can be configured with the command *ti[].
*ti[_] Time out:
*ti[0 .. 180] time parameter for lock code 2 from 0 [s] to 180 [s] (default
10 [s], example *ti10)
*sk[_] Skip time slot on no response:
*sk0 skip on no response off
*sk1 skip on no response on (default)
*ct[_] Collision threshold parameter:
*ct[0 .. 100] parameter from 0 to 100 (default 33, example *ct33)
*cs[_] Channel Selection:
*cs0 channel I (default). Cable length must be 3,66m.
*cs1 channel I and Q. There are no limitations on the cable length.
*et [_] Communication selection :
*et0 ethernet
*et1 RS232
*et2 RS232 and ethernet (default)
* see ISO 15693 for more details
Time of transponder out of the field
transponder
t
t
0
t
1