User's Manual

Installation & Operation Manual V 1.0 7 (19)
IMPORTANT:
Please place the antenna as far as possible from metallic surfaces to avoid possible reading
interferences and avoid to mount it in places where a regular ventilation is not granted.
If the light “Antenna” turns on, the antenna might be too close to metallic surfaces or not
tuned.
After the reader is turned on for some time the temperature might increase.
Do not plug/unplug any connectors while the reader is turned ON.
In case you have an R-IN7500 LF reader installed you can keep the same configuration. You just
need to unplug the serial cable from the PC and connect it to the R-IN1300 reader to the connector
marked as “Secondary Interface”.
If you have a new R-IN7500 NMS:
1. Connect the Low Frequency (LF) Antenna to the connector marked “Ant.0” on the reader
2. Connect a serial cable the connector “RS-232” mentioned on the R-IN7500 to the connector
“Secondary Interface” mentioned on the R-IN1300 reader.
3. Connect the power cable
4. Turn the reader on
Keep a distance between the LF and the HF antenna (min. 1m) in order to not influence the
reading distance or use a combo antenna (A-ST1330 CBO) to read LF and HF transponders at
the same time with the same antenna.
2.1 MOUNTING
The reader can be simply laid down on the table or be mounted on the wall or under a table using the
appropriate wall mounting system.