User's Manual

4.9 READER SETUP
The “ReaderSetup” tab allows users to specify overall properties of the reader.
It is possible to specify:
the antenna power:
0 mW – 4 000 mW (1000 mW = 1 W; 2000 mW = 2 W; etc. )
the technologies of the transponders being used:
ISO-15693
I-Code I
the ISO-15693 properties (see corresponding ISO-specification)
Request/Response Data Rate
Modulation Type/ Modulation Index
Quiet Mode /Quiet Storage
Time Slots
The “Lock Code” field specifies a particular behaviour of the reader: Details for LockCode 0:
Disabled.
Details for LockCode 1: Any transponder is read just once. To read a transponder again, another
one must be read first.
Details for LockCode 2: The transponder is first visible when entering the magnetic field the first time
and it is detected only once without regard to the time spent in the field. A chip having left the
magnetic field can be read again only having spent an amount of time T outside of it. If the time spent
outside the magnetic field is less than T, the chip cannot be detected.
The “Communication” field specifies on which output channels the reader must write the found UIDs.
The “Echo” field specifies whether the user-input written onto the terminal (RS-232) must be shown
on the screen or not.
The “Reverse Order” field specifies the representation of the UIDs:
Reverse Order Off : Uids are not reversed
Reverse Order On : Uids are reversed
R-IN1300 MID Manual – v. 1.2 – August ‘08 17 (29)