User's Manual
Table Of Contents
- 1 Introduction
- Hardware connections
- Operation with Terminal
- 4 Operation with Graphical User Interface (GUI)
- Connecting with the COM (RS-232)
- Connecting with Ethernet (Recommended)
- General Considerations
- 4.4 Connect (Serial version only)
- Login (Web Server version only)
- Logout (Web Server version only)
- Network Setup
- 4.8 RS 232 Setup
- Reader Setup
- Advanced Reader Setup
- Configurations
- Monitor
- Firmware Update
- How to install the RS-232 interface
- System Requirements
- 5 Technical Specifications for R-IN1300 MID
- Appendix A – Connecting the R-IN1300 MID to a PC with a cross cable
- Appendix B - Code length
- Appendix C - Troubleshooting
READ/WRITE
Read / Write
EMC
High attenuation characteristics (~30÷60 dB)
IP PROTECTION DEGREE
IP30
MAX. READABLE TRANSPONDERS
1000 pieces
Hot The housing might become hot!
5.3 REGULATIONS
5.3.1 EQUIPMENT MODIFICATION
Equipment modifications not expressly approved by Datamars SA, CH-6930 Bedano, the party
responsible for FCC compliance, are forbidden. Such modifications could void the user’s warranty and
authority to operate the equipment and cause hazardous conditions.
5.3.2 EN 300330-1/-2 (EUROPE)
The R-IN1300 MID system is a sending and receiving equipment and is in accordance with the R &
TTE directive
EN 300 330-1/-2.
The R-IN1300 MID system fulfils the requirements of this regulation.
5.3.3 FCC (USA)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.
R-IN1300 MID Manual – v. 1.2 – August ‘08 25 (29)