User's Manual
Table Of Contents
- 1 Introduction
- Hardware connections
- Operation with Terminal
- 4 Operation with Graphical User Interface (GUI)
- Connecting with the COM (RS-232)
- Connecting with Ethernet (Recommended)
- General Considerations
- 4.4 Connect (Serial version only)
- Login (Web Server version only)
- Logout (Web Server version only)
- Network Setup
- 4.8 RS 232 Setup
- Reader Setup
- Advanced Reader Setup
- Configurations
- Monitor
- Firmware Update
- How to install the RS-232 interface
- System Requirements
- 5 Technical Specifications for R-IN1300 MID
- Appendix A – Connecting the R-IN1300 MID to a PC with a cross cable
- Appendix B - Code length
- Appendix C - Troubleshooting
APPENDIX A – CONNECTING THE R-IN1300 MID TO A PC WITH A CROSS CABLE
If the reader “R-IN 1300 MID” is directly connected to a PC, you must still do following steps:
Open the “Network Connections” frame of Windows (Hint: Start -> Settings -> Network
Connections) and double-click the entry corresponding to the connection you intend to use to
communicate with the reader. You will see a similar frame:
Click the button “Properties” of the tab “General” to get access to the “Connection Properties” frame. You
will see a similar frame:
Highlight the “Internet Protocol (TCP/IP)“ and click the “Properties” button to get access to the
“Internet Protocol (TCP/IP) Properties” frame. You will see a similar Frame:
Note exactly the current configuration of the tab “General” in order to be able to restore it.
Click the “Use the following IP address” radio-button and specify an IP in the same range of the
readers IP (i.e. 192.168.1.1), the subnet-mask (255.255.255.0). You can ignore the “Default
Gateway”.
Leave the configuration tool confirming by clicking the OK button.
R-IN1300 MID Manual – v. 1.2 – August ‘08 27 (29)