User's Manual
Table Of Contents
- 1 Introduction
- Hardware connections
- Operation with Terminal
- 4 Operation with Graphical User Interface (GUI)
- Connecting with the COM (RS-232)
- Connecting with Ethernet (Recommended)
- General Considerations
- 4.4 Connect (Serial version only)
- Login (Web Server version only)
- Logout (Web Server version only)
- Network Setup
- 4.8 RS 232 Setup
- Reader Setup
- Advanced Reader Setup
- Configurations
- Monitor
- Firmware Update
- How to install the RS-232 interface
- System Requirements
- 5 Technical Specifications for R-IN1300 MID
- Appendix A – Connecting the R-IN1300 MID to a PC with a cross cable
- Appendix B - Code length
- Appendix C - Troubleshooting
2 HARDWARE CONNECTIONS
1. Antenna:
Connect the black coaxial cable from the antenna to the connector marked as “Antenna”.
You can not use cable other than the 3.5m coaxial 50Ω cable supplied by
Datamars. Additional extension cables at disposal.
2. PC/Terminal or Ethernet
Connect the serial white cable from the connector marked “Host” to any serial port (COM) on
your PC or the reader “R-IN 1300 MID” can be connected to the LAN just like a PC (Ethernet
cable & RJ-45 connectors).
A direct Ethernet connection between a PC and “R-IN 1300 MID” reader is also possible, with
an Ethernet Cross Cable (supplied together with the reader). Refer to Appendix A for more
details on how to do this.
3. Power
Connect the power cable 110 – 240 V AC and be sure that it is well fixed.
4. Set the Power Switch to ON and check if the green LED (Power) is on.
5. Wait until light “Tag” stop flashing (~20 seconds).
Green light on
R-IN1300 MID Manual – v. 1.2 – August ‘08 4 (29)