User's Manual
Table Of Contents
- Contents:
- 1 Description
- 2 Operation
- 3 Managing the menu
- 4 Connect your R-PO7470 to a PC
- 5 Battery managment
- 6 Take care of your reader
- 7 Specifications
- 8 Regulations
- 9 Technical supplement – Console commands
- 9.1 Introduction
- 9.2 How to connect the R-PO7470 to a PC through USB
- 9.3 How to connect the R-PO7470 to a PC through BlueTooth
- 9.4 Console commands description
- 9.4.1 Get firmware version command
- 9.4.2 Read remotely command
- 9.4.3 Sets the date’s year
- 9.4.4 Sets the date’s month
- 9.4.5 Sets the date’s day of the month
- 9.4.6 Sets the date’s day of the week
- 9.4.7 Sets the current date format
- 9.4.8 Gets the current date format
- 9.4.9 Gets the current date
- 9.4.10 Sets the time’s hour
- 9.4.11 Sets the time’s minute
- 9.4.12 Sets the time’s second
- 9.4.13 Gets the current time
- 9.4.14 Clears the memory’s data
- 9.4.15 Downloads the memory’s data
- 9.4.16 Clears the message area
- 9.4.17 Write a message to the display
- 9.4.18 Sets the “store in memory” function
- 9.4.19 Gets the “store in memory” function status
- 9.4.20 Sets the “memory hit” function
- 9.4.21 Gets the “memory hit” function
- 9.4.22 Sets the “selected hit” function
- 9.4.23 Gets the “selected hit” function
- 9.4.24 Sets the “reading beep” function
- 9.4.25 Gets the “reading beep” function status
- 9.4.26 Sets the “key beep” function
- 9.4.27 Gets the “key beep” function status
- 9.4.28 Sets the reading timeout
- 9.4.29 Gets the reading timeout
- 9.4.30 Sets the shutdown timeout
- 9.4.31 Gets the shutdown timeout
- 9.4.32 Sets the VCP baud rate
- 9.4.33 Gets the VCP baud rate
- 9.4.34 Sets the “auto shutdown” function
- 9.4.35 Gets the “auto shutdown” function status
- 9.4.36 Firmware update function
- 9.4.37 Character length function
2.2 Read a transponder
Place the R-PO7470 near the item to be read then press the START button to activate the
reading mode.
Reading mode
During reading mode; move the reader along the item to scan the transponder ID.
To stop the reading mode press the START button again.
The following figure shows the result of a successful reading session:
Thu 07.02.08 14:48:22
85%
PSK
D0060BAFF5
Type
1. Transponder type
2. ID code
1. The transponder type for Industrial application is PSK and it is a Datamars transponder
2. Identity Code number.
The following figure shows the result of an unsuccessful reading session:
After a while the reading mode times out. The reader stops and shows the message “NO TAG
FOUND”.
R-PO7470 Manual – v. 1.1 – August 2008 6