User Guide Owner manual

1.4 Attaching Belt Loop System

The belt loop system consists of two parts as seen in Figure 5:

 A knob located on the back part of the printer just above the battery door

 A strap with click on connector

To attach the strap to the knob insert the knob located at the bottom of the printer into the

slot of the connector. Pull down until you hear a click. The printer is now secure. The loop is

then placed over your belt. Allow the printer to hang down to either the left or right hip.

 To release the printer, press in on the two latches on the connector and pull the knob

clear of the slot.

Note: Do not force or pull the printer from the connector without pressing in on the two

latches

KNOB CONNECTION

FIGURE 5– KNOB CONNECTION AND QUICK CLIP