Programmer's Manual

Extended System-Level Command Functions
58
Item
Number
Name Available
to User
(Y/N)
Value Type Description
8 Passkey Y String String up to 16 characters.
Valid characters are
alpha/numeric. Default – not
used.
0=no
1=yes
9 Inactive Disc Time Y Int 0 to 65535. Default is 60
(Read and Write)
10 Power Down Time Y Int 0 to 65535. Default is 60 (
Read and Write)
11 Bluetooth Address Y String 12 hexadecimal characters
(similar to MAC address) (Read
Only)
(BZ) Buzzer Enable – This command controls the audible signaling device that
acknowledges User Interface entries and, if enabled, sounds printer warning and
fault conditions.
(CC) Control Codes – This command, depending upon printer type, allows a change
to the prefix of the software commands interpreted by the printer:
Value
Units /
Interpretation
Control Code Definition
S Standard Codes
Hex 01 = SOH command; Hex 02 = STX command; count-
by = ^; Hex 1B = ESC; Hex 0x0D = Carriage Return
1 Alternate Codes
Hex 5E = SOH command; Hex 7E = STX command; count-
by = @; Hex 1B = ESC; Hex 0x0D = Carriage Return
2 Alternate Codes 2
Hex 5E = SOH command; Hex 7E = STX command; count-
by = @; Hex 1B = ESC; Hex 0x7C = Carriage Return
(CE) Cutter Equipped – This command allows the printer to sense the cutter option.
“A” - automatically senses device presence; if undetected, no error is generated. “E” -
enables the device, where its presence must be detected; otherwise, a fault is
generated. “N” - disables device detection. One of these values is returned in
response to <STX>KcQQQ. Note that alternate values are accepted for backward
compatibility as follows: “Y” is equivalent to “A”.
(CF) Column Adjust Fine Tune – This command fine-tunes the Column Offset
setting by shifting both the horizontal start of print position and the Label Width
termination point to the right in dots (see Appendix K) to compensate for slight
mechanical differences sometimes evident when multiple printers share label
formats.