Programmer's Manual

Extended System-Level Command Functions

(NR) No Reprint – This command controls the label reprint function following the

correction of a fault condition. Upon detection of a fault (ribbon out, paper out, etc.),

printing stops and a fault indicator is illuminated. After the problem is corrected, the

FEED Key must be pressed to clear the fault and resume normal operation. When

enabled, the label in process is not reprinted.

(NS) Disable Symbol Set Selection – This command prevents the <STX>y and y

commands from changing the default single-byte symbol set. When enabled, DPL

Symbol Set commands are ignored.



When enabled, the only way to change the current symbol set is with the <STX>KcAS

command.

(OF) Option Feedback Mode – This command configures the printer to output the

status of the RFID or Scanner option to the active port, as follows.

Value Option Feedback Mode Units / Interpretation

D, Rx, S

= Disable

RFID Enable, where x is the response format:

A = ASCII

H = Hexadecimal

= Scanner Enable

Once enabled, the printer will report information about the results of the last label

printed. One response per label is returned to the host (this includes each voided and

retried label). The format and contents of the returned information is as follows: