92-2324-01 Rev.
Contents of the Peel and Present Kit This kit contains the following items: Peel and Present Assembly Platen Roller Assembly Note: When using the Peel and Present Option do not exceed print or slew speeds above 6 IPS. Tools Required The Peel and Present Option requires a #2 Flat and #2 Phillips screwdriver for installation. Preparing the Printer Turn the power off and unplug the printer. Remove any installed media from the printer.
Replacing the Platen Roller Note: Inspect your printer and determine if the Platen Roller Assembly installed in your printer includes the Integral Gear as shown to the left. If the Integral Gear is present it is not necessary to replace the Platen Roller Assembly, proceed to ‘Installing the Peel and Present Assembly’ Integral Gear Remove the Sensor Cover by pulling it from the printer in the direction of the arrows, as shown.
Installing the Peel and Present Assembly Position the Peel and Present Assembly on the front of the printer and then tighten the mounting screw. Peel and Present Assembly Mounting Screw Options Connector Route the Present Sensor Cable along the Baseplate and on the inside of the Cable Guide as shown. Plug the end into the Options Connector as shown.
Setup and Configuration The printer will automatically sense the presence of the Present Sensor and allow it to be enabled for present printing. If you wish to enable the Present Sensor it must be enabled within the menu system. To ‘Enable’ or ‘Disable’ the Present Sensor follow the steps below. Verify the printer is in the ‘Ready Mode’ Press the button. Using the button scroll to ‘Printer Options’ and press the button. Using the button scroll to ‘Present Sensor’ and press the button.
Peel off at least 20 inches of labels from the label backing. Route the label backing as shown below. Route the Label Backing back to and around the Rewind Hub. Insert the edge of the Label Backing into the Slot on the Rewind Hub. Then insert the Media Retainer, (supplied with the Rewind Option) into the Slots on the Rewind Hub and rotate the Rewind Hub to remove any slack in the Label Backing. Label Backing Slots Label Backing Rewind Hub Media Retainer Close the Peel Mechanism Front Cover.
Periodic Maintenance The Peel Mechanism Rollers will need to be disassembled and cleaned approximately every 100,000 inches to ensure trouble free operation. This cleaning interval may be more or less depending on the type of adhesive on the back of your media. Heavy or “gummy” adhesive will require more frequent cleaning. Upper Rollers: C-Clip Remove the Peel Mechanism from the printer. Press in on the Latch and allow the Front Cover to swing open.
Lower Rollers: Remove the Peel Mechanism from the printer. Press in on the Latch and allow the Front Cover to swing open. Push in on the Tab as shown, repeat for the other side and then remove the entire Lower Roller Assembly. Push in on Tab Lower Roller Assembly Remove Lower Roller Shaft and associated Rollers. Note the order of the Rollers as they are removed, they must be re-installed in the same order. Lower Roller Shaft Clean all surfaces of the Rollers and the Lower Roller Shaft.
