92-2491-01 Rev.
Overview This document describes the contents and installation of the Media Hub options for the M-Class MII printer. Only qualified service personnel should perform this installation. After verifying the kit contents and the tools needed, follow the steps below to install the option. Contents The contents of the Media Hub Kit differ according to kit number: (3-Inch Media Hub Kit) contains the following items: 1 1.
Installation Only qualified service personnel should perform this installation. Always wear a wrist strap and follow standard ESD prevention measures when handling any printer CAUTION circuit card assembly. A) Turn OFF the Power Switch and unplug the power cord from the AC Receptacle. Power Switch Disconnect the interface AC Receptacle cable(s). Cover Screws B) Remove the Cover Screws on the outside of the printer. Cover Cover Screws C) Raise the Cover.
Main Logic Card D) Disconnect the cables from the Main Logic Card. Card Cage Screws E) Remove the Screws that secure the Main Logic Card and the Fill Plate to the Card Cage. Remove the Fill Plate then slide the Main Logic Card out of the printer. Main Logic Card Fill Plate Centerplate F) Remove the Hanger Screws Media Hanger that secure the Media Hanger to the Centerplate and then remove the Media Hanger.
Main Logic Card J9 J11 G) Slide the Main Logic Card J14 into the Card Cage and J10 replace the Fill Plate. Secure the Main Logic Card and the J8 Fill Plate using the previously J12 removed Screws. Reconnect all the cables to the Main J7 Logic Card. J16 J4 J6 J5 Power Supply Screws H) Remove the Ground Strap Screw and Lock Washer, four Power Supply Screws, and two Line Filter Screws. Remove the Line Filter Line Filter Screws Bracket and then remove the Power Supply.
Power Supply Screws J) Install the Power Supply then place the Line Filter Bracket onto the Line Filter. Secure the Power Supply Line Filter Bracket Screws using the Power Supply Screws and the Line Filter Screws. Line Filter Power Supply Line Filter Bracket K) Insert the Ground Strap Screw into the Lock Washer and the Ground Strap Lug. Then secure the Ground Strap Lug to the chassis using the Ground Strap Ground Strap Screw and Lock Washer Screw and Lock Washer.
Cover Screws M) Tighten the Cover Screws on the Centerplate. Centerplate N) Connect the interface cable(s). Plug the power cord into the AC Receptacle and turn ON the Power Switch. Power Switch This completes the installation process; refer to AC Receptacle the Operator’s Manual for media loading instructions. Note: The 3-Inch Media Hub Hub Adapter Kit is configurable: To install the Hub Tabs Adapter (Item 3), Tabs align the Tabs then slide the Hub Adapter over the 1.
