92-2479-01 Rev.
Contents of the Peel & Present Kit This kit contains the following items: Peel and Present Mechanism Assist Roller and Bushing NOTE: If this option was ordered with the printer the Assist Roller and Bushing will already be installed in the printer. Proceed to Step 3: Installing the Peel & Present Mechanism. Otherwise follow the steps below to install these items into the printer. Other Requirements This option requires the Internal Rewinder option. Contact your sales representative for more information.
Using a #2 Philips head screwdriver, remove the Screw that secures the Side Plate to the printer. Remove the Side Plate. Side Plate Screw Using a #2 Philips head screwdriver, remove the Screw that secures the Bearing Cap to the printer. Remove the Bearing Cap and the Hole Plug. Hole Plug Bearing Cap Screw Step 2: Installing the Assist Roller Insert the Assist Roller, as shown, gears first into the printer. Pivot the other end of the roller into the Bearing Block.
Insert the Bushing completely into the Bearing Block. Bearing Block Assist Roller Bushing While holding the Assist Roller Bearing against the Centerplate, replace the Bearing Cap. Hold the Bearing Cap in place and secure it with the Screw. Side Plate Bearing Cap Screw Screw Centerplate Replace the Side Plate and start, but do not tighten the Screw.
Ensure that the Leveling Cam is loose, and then close and latch the Printhead Assembly. Printhead Assembly While pushing down on the Printhead Assembly, as shown, pull down on the Side Plate and tighten the Screw. Leveling Cam Screw Side Plate Verify Latch Operation: - Open and close the printhead assembly, verify that the latch is fully engaged. If you are unable to get the printhead to latch, the side plate is too low.
Loading Media With the Peel and Present option, labels printed in a batch will be automatically be separated from the backing material and dispensed “on-demand”– that is, printing will occur only after a previously printed label has been removed from the printer. Press in the Latch to open the mechanism. Swing the mechanism open. Load the printer with media (see the Operator’s Manual for detailed instructions).
Route the Backing Material under the Assist Roller and around the Internal Rewinder, as shown below. Backing Material Slots Media Clip Retainer Backing Material Internal Rewinder Thumbscrew Assist Roller Note: The Media Retainer can be used in place of the Media Clip for a more consistent rewound roll. The Media Clip and Media Retainer cannot be used together. Put the leading edge of the Media into a Slot on the Internal Rewinder and insert the Media Clip.
Setup, Configuration, and Operation The Peel and Present option is plug and play; no setup or configuration is required. As soon as power is applied, the printer senses and enables the Present Sensor for operation. During operation, when a label is present (blocking the sensor), the yellow Stop Light on the front panel of the printer will flash to prompt you that a label awaits removal.
Upper Roller Shaft Remove Upper Roller Shaft and associated Rollers. Rollers Clean all surfaces of the Rollers and the Upper Roller Shaft. Isopropyl Alcohol can be used, for heavy or stubborn deposits WD-40 or an adhesive remover can be used. Be sure all the ridges on the rollers are free of debris. Re-assemble the Upper Roller Shaft, Rollers, and C-Clip into the Peel Mechanism Assembly. Lower Rollers: Remove the Peel Mechanism from the printer.
