92-2553-01 Rev.
Overview This document describes the contents, installation, and use of the Cutter option for the MP Compact printers. After verifying the contents of the kit and the tools needed, follow the steps below to install and begin using the option. For your safety and to avoid equipment damage, always turn ‘Off’ power and unplug the CAUTION printer’s power cord before beginning this installation and when performing service.
Installation 1. Move the right front rubber foot with screw from the printer to the front right on the cutter. 2. Mount the washer and the screw, to old foot position on the printer. 3. Remove the other feet. Mount the three feet on the cutter with the 3 new M3x12 screws. 4. Remove the front lid by pulling out the front lid shaft. Insert the shaft again. 5. Place the cutter holder under the printer and fasten with the four M5x14 screws. 6. Attach the cutter cable to the contact in the middle.
Setup and Loading By default the cutter is set to operate automatically every time a label is printed out. It will cut between each label. Host configuration utilities such as DMXConfig and Tera Term can be used to adjust the feed and reverse feed rate and if needed, to adjust the cutting position. The cutting function can also be changed to cut on command instead of automatically. 2 1. Set the lever to release. 2. Pull out the locking screw to open the cutter. 3.
