92-2619-01 Rev.
1 Safety Warnings and Cautions The following Warnings and Cautions are used throughout this manual: Warning: Warnings alert you to possible safety risks. Caution: Cautions alert you to the potential for equipment damage. General Safety Information Caution: This product is intended for indoor use only. All service procedures should be done by properly trained and qualified service personnel.
2 Cutter Installation Guide Cutter and Tray Option Figure: 2 - 1 Cutter Assembly Figure: 2 - 2 Tray Assembly 3 Cutter Installation Guide
2 | Cutter Installation Guide Safety Overview Caution: ESD protection is required when performing these steps. Warning: The cover set may only be removed by a Datamax-O’Neil Authorized Service Center. Unauthorized service will void the manufacturer’s warranty. Warning: The printer must be powered off and disconnected from utility power prior to performing these procedures. Failure to heed this warning may result in personal injury or damage to internal components.
Cutter Installation Guide | 2 Cutter and Tray Installation Procedure Warning: To prevent serious injury, never place a finger or object other than media near the cutter mechanism. Caution: Never cut paper or media in an area where adhesives exist. Doing so will damage the cutter and void the manufacturer’s warranty. Caution: The media cover will not close with both the cutter and present sensor installed at the same time.
2 | Cutter Installation Guide 2. Loosen and remove the media plate thumbscrew and the media plate. Figure: 2 - 4 Remove Media Plate Note: Retain the thumbscrew for cutter installation. 3. Align the cutter with the power/data connector and install the thumbscrew to secure it to the platen carriage assembly.
Cutter Installation Guide | 2 4. Rotate the cutter until it magnetically locks into place. 5. Activate the cutter option in the Options menu by selecting Menu > Advanced > Printer > Options > Cutter. Note: Feed a label through the printer and observe the cut distance to ensure it cuts on the gap. If it cuts on the label, adjust your Cut Distance Adjust settings in the Adjustments menu. Note: A negative value moves the cut line toward the current label being printed.
