10273-000 Rev.
Safety Precautions This Power Converter is intended for use on fork lift and similar vehicles with a battery voltage of 12-60VDC. Once the Power Converter is properly installed it will reduce the voltage to the printer to 12VDC which is suitable for charging. This document describes the installation and use of the Power Converter for the RL4 and other Datamax-Oneil printers. After verifying the contents of the kit and the tools needed, follow the steps below to install and begin using the option.
Cable Connections To Printer Optional 10’ Extension Cable Kit available, Part# 220207-200 B+ 12-60 VDC B+ 12-60 VDC 12V-24V = 8A 36V-60V = 5A Yellow ■ Yellow ■ Yellow ■ Yellow ■ Yellow ■ Yellow ■ Yellow Red ■ Red ■ Red ■ Red ■ Red ■ Red ■ Red Black ■ Black ■ Black ■ Black ■ Black ■ Black ■ Black Determine the best method for connecting the power converter the power source and for routing the cable, taking into consideration the following principles.
