RL3/4 Printer Mounting System 2 1 3 T= 6-8 inlb / .68-.90 Nm Ø 1.5” (38.1mm) 4 5 Arm and Mounting Ball not included. See www.ram-mount.com for available options.
6 Important Notes: • Use of Loctite® due to vibration is recommended on mounting screws. • Read and follow all safety and installation guidelines for use of RAM® products. • Be sure to observe and follow all safety guidelines for installation on a forklift or any other vehicle. • Never try to adjust or operate the printer when a vehicle is in motion.
