Programmer's Manual Owner manual

DTPL Programmer’s Manual 4

Font Size Command

<Fx>

This command sets the font size. The defaults is F3.

1 for Font1 characters (5x7)

2 for Font2 characters (8x16)

3 for OCRB (17x31)

4 for OCRA (5x9)

6 for large OCRB (30x52)

7 for OCRA (15x29)

8 for Courier (20x40)(20x33)

9 for small OCRB (13x20)

10 for Prestige (25x41)

11 for Script (25x49)

12 for Orator (46x91)

13 for Courier (20x40)(20x42)

Graphics Command <G>byte1,byte2,byte3,byte4,byte5,b

yte6,byte7 or

<G#>byte1,byte2...byte#

Sets the printer to Graphics Mode and sends graphic data to the

printer.

Height/Width Command <HWx,y> Multiplies the normal character height by x=Width and y=Height

Printing Length Command <PL#> Changes the normal printing length to a user defined unit length.

Each unit equals .0098” or 2 dots

Permanent Printing Length

Command

<pl#> Changes the normal printing length to a user defined unit length.

Each unit equals .0098” or 2 dots and saves the value in the printer’s

Flash memory.

Permanent Ticket Length

Command

<tl#> This command should only be used if the ticket length is greater than

the printing length. This value is stored in the printer’s Flash

memory.

Repeat Command <RE#> Allows the printing of any number (up to 9999) tickets without re-

transmitting the data.

Rotation Command <NR> No rotation

<RR> Rotate right (+90)

<RU> Rotate upside down (+180)

<RL> Rotate left (+270 or - 90)

This command sets the rotation mode for all the following text data.

Row/Column Command <RCx,y> This command positions the character at the row (x) and column (y).