Manual
Cables
As s embly o f the Paper Tray:
1. Assemble the Paper Tray to the Dash Mounting Plate with
(4) #8-32 x ¼” Button head Screw s with 3/32” Allen
wrench ( Fig. 13 ). Paper Tr ay ma y be installed with long
end towards the user or away from the user, depending
on dashboard conguration. The Dashmount with Pape
r
Tra y and Foam Block (smooth side up) should appear as
in Fig.14 .
2. Install Dashmount to dash via mounting holes and slots in
the Dash Mounting Plate.
Printer installation ( Dash mo un t Kit) :
1. Assemble the VMP-1000 printer to the Dashmount using
(4) #10-32 x 5/8” screws ( Fi g. 16 ). Tighten hardware at
the four mou nting slots at the bottom of the printer.
Secure printer to bracket w ith (1) #8-32 x 5/8 ” securit
y
screw.
2. Route the power and data cables into the trough of the
Printer Mounting Plate as shown in Figs. 16, 17, & 18 .
As s embly o f the Vibrati on Isolation Bracket (Deluxe Kit):
1. Before mounting the Vibration Isolation Bracket (220146-
000, included in Deluxe Kit), make sure the Rubber Feet
are on the Plate correctl y. The ends of the Plate should t
into the recess in the Rubber Feet. Put the side with the
rubber bosses closest to the edge facing up ( Fi g. 1 9 ).
2. Place Foot Caps on the Plate with the recesses facing up
and out.
3. Mount the b racket with (4) #10-32 x 1” screws and (4) # ¼
- 20 washers to (Fig. 20 ). Do N ot overtigh ten as it may
damage t he Foot Cap.
4. Top of screw head must clear the height of the uppermost
surface, for the printer to slide into
place.
Printer installation (Deluxe Kit):
1. Note orientation of printer & locking rivets on bracket ( Fig.
21).
2. Slide printer into position until Locking Snap “clicks” ( Fi g.
22).
3. Secure the printer to bracket with either the supplied #8-
32 security screw (special bit T15 Torx w/ security pin
required) or # 8 Phillip s pan
-head self-locking screw.
4. Route the power and data cables as shown in Figs. 16,
17, & 18 .
6
F ig. 22
Locking rivets
Fi
g
. 21
Locking Snap
Security/Phillips
screw
F ig. 17
Cables
F ig. 18
Cables
10-32 x 5/ 8”
Scre w
Trou
g
h
Security
Screw
Fi
g
. 16
Mountin
g
holes
Fi
g
. 15
F ig. 14
#10-32 x 1” &
#¼ - 20 Washer
Fi
g
. 20
Foo t Ca
p
R ubber Foot
F ig. 19
F ig. 13
5
Cables
Dashmount Bracket
VMP1000/2000
110092-002