Owner's manual

Wall Mount Vibration Bracket
(220199-000)
The following parts are included with the wall mount
bracket (Figure 1):
(1) Wall mount bracket
(4) Shock mount top bushing
(4) Shock mount bottom bushing
(4) ¼” x 1” diameter Fender washer
(1) #8-32 x 3/8 Phillips pan head screw
(1) #8-32 x 3/8 Torx pan head screw
(1) Instruction sheet [not shown]
The following hardware (not included) is required for
mounting:
(4) ¼ - 20 pan head screws [screw length to be
determined by user]
(4) ¼” Washer
(4) ¼” Hex nuts to match screws
(1) Drill with #7 [0.201”] bit or similar size
(1) #1 Phillips screwdriver
(1) #8 Torx screwdriver [optional]
Figure 1
Security
Catch
Top Paper
Guide
Bottom
Paper
Guide
Torx Screw
Phillips Screw
Mounting
Holes
Top and Bottom
Shock Mount
Bushings
Fender
Washers
Paper
Slot
Selecting a Location for the Bracket
Orientation Guidelines
Use the following information as a guide for
orienting and/or mounting your printer (Figure 2):
* When the printer is mounted to the bracket, the
paper feeds from the mounting surface toward
you. For VMP 1000 printers, you must use the Line
Feed Hold configuration command (available with
firmware version 2.26 or higher) to maintain Top of
Form (TOF) and control the line feed motor. For
information on using the configuration program,
refer to the Datamax-O’Neil Programming Guide
.
If firmware version 2.25 or lower is installed on
your printer, download the latest firmware version
from www.datamax-oneil.com.
VMP 1000
XY
0° to 45° 0° to 30°
Firmware Version*: 2.26 or higher
Configuration Command*: Line Feed Hold:
{CR:Y}
VMP 2000
XY
0° to 15° 0° to 30°
Figure 2
X
Y
0°
Paper In
Paper
Exit
X
0°
Y
Selecting a Location for the Bracket
(continued)
General Guidelines
• Position the bracket and/or printer with enough
room to properly open and close the printer.
• Position the bracket and/or printer so it is
protected from environmental elements such as
moisture, tools, and boxes.
• Position the bracket and/or printer in a secure
area in normal traffic patterns.
• Do not position the bracket above, near, or
relative to, the driver's position as to interfere
with normal driving operations.
• Mount the bracket and/or printer away from the
driver's head to eliminate potential injury in the
event of an accident.
• Cabling: All power to the printer must be fused.
Make sure the fuse box is connected properly.
• Hole centers:
Left to right = 9.590"
Up and down = 8.723"
Recommended hole diameter for ¼ -20 pan
head screw is #7 drill bit (.201").
Assembling the Bracket
1. Attach the top shock mount bushings to the
wall mount bracket (Figure 3).
2. From under the bracket, attach the bottom
shock mount bushings to the top shock mount
bushings (Figure 4). The bracket should be
between the bottom shock mount bushings
and the top shock mount bushings.
3. Place the fender washers over the recesses
of the top shock mount bushings (Figure 5).
The washers attach to the top shock mount
bushings after the bracket is mounted.
4. Proceed to Mounting the Bracket.
Figure 3
Figure 4
Figure 5