User's Manual

OC-2 SERIES OF PRINTERS USER'S GUIDE
16
Using the Belt Clip
Installing the Belt Clip
1. Place the belt clip's head over the printer's swivel mount
block (Figure X).
2. Rotate the belt clip clockwise and/or counter-clockwise 180
degrees to lock the belt clip into place (Figure X).
Removing the Belt Clip
1. Rotate the belt clip so that the belt clip is in the “Up”
position as shown Figure X.
2. Lift the belt clip off the printer. Do not force the belt clip off
the printer. When positioned properly, the belt clip easily
lifts off the printer. If the belt clip does not easily lift off, re-
position the belt clip.
Figure X
Figure X
Figure X
LP3.book Page 16 Wednesday, April 12, 2006 4:41 PM