Programmer's Guide User guide

1 | Programmer’s Guide
Thermal Printer Programmer’s Guide 38
PRINTONGAP Sets the printer to print on gap/
mark or not
OFF, ON OFF
DARKNESS
7
This allows for the adjustment of
the darkness of the printed
image due to printhead thermal
variations.
± 20 0
SHARPNESS
4, 7
This allows for the adjustment of
the leading edge darkness of
the printed image due to
printhead thermal variations.
± 10 0
CONTRAST Same as SHARPNESS ± 10 0
VERTICALADJ
4
This allows for the vertical
adjustment of the start of image
relative to the horizontal leading
label edge due to mechanical
variations.
± 100 (dots) 0
HORIZONTALADJ
4
This allows for the horizontal
adjustment of the image relative
to the printhead center.
± 100 (dots) 0
PRESENTDISTANCEADJ
4
This allows for the adjustment of
the tear bar position due to
mechanical variations.
± 100 (dots) 0
CUTDISTANCEADJ
4
This allows for the adjustment of
the cut position due to
mechanical variations.
± 100 (dots) 0
HEADPRESSUREADJ
4
This allows for the adjustment
the pressure the printhead
exerts down on the media.
± 5 0
RIBBONTENSIONFADJ
4
This provides for the adjustment
of the front ribbon motor
± 10 0
RIBBONTENSIONRADJ
4
This provides for the adjustment
of the rear ribbon motor
± 10 0
REWINDTENSIONADJ
4
This provides for the adjustment
of the rewinder motor.
± 10 0
PAPERTRANSLEFT
4
Paper transmissive sensor
threshold for the inside sensor
0-255 128
PAPERTRANSRIGHT
4
Paper transmissive sensor
threshold for the outside sensor
0-255 128
PAPERREFLUPLEFT
4
Paper reflective sensor
threshold for the top inside
sensor
0-255 128
PAPERREFLUPRIGHT
4
Paper reflective sensor
threshold for the top outside
sensor
0-255 128
PAPERREFLDOWNLEFT
4
Paper reflective sensor
threshold for the bottom inside
sensor
0-255 128
Variable Description Range Default