Operator`s manual

A-Class 103
5.5.1 Updating the Application Version
 Note: If Security has been enabled, disable the feature before proceeding (see Section 4.2.5).
Step Displayed Message Operator Action Comment(s)
1
!
READY
!
Using the DOS copy
command (where ‘filename’
is the program to be loaded
and ‘lpt1’ is the selected
interface port), enter the
following:
copy filename lpt1:
As an example, this would be entered as:
copy A4212tb
~
1.zs lpt1
(Where ‘lpt1’ is the host computer’s port;
however, this selection can differ to
include a serial or other port, as the printer
is equipped.)
The Comm Indicator will flash as data is
received.
2
UPGRADING
SOFTWARE
!!
No action required.
The new application program is being
stored and verified.
3
A4212
8.00 10/01/2003
!!
No action required. The printer has automatically reset and is
now displaying the new firmware version.
4
!!!
READY
No action required.
The new application is now running.
 Note: If ‘Uncalibrated’ is displayed, the
printer must be calibrated (see Section 5.1).