Operator`s manual

A-Class 115
Printer Fault Messages (continued)
Displayed Message Description Possible Solution(s)
!
TOP OF FORM FAULT
!!
!
The printer could not find the TOF
mark within the maximum label
length setting or it found a TOF in
an unexpected place.
 Note: When the SENSOR TYPE is set
to REFLECTIVE, this fault is given for an
out of stock condition.
If media is moving:
1) Press the FEED Key. It may be
necessary to re-calibrate the
printer; see Section 5.1.
2) The Media Sensor may be out of
position. Readjust it; see Section
3.5.
3) The media may not be properly
loaded. Reload media, also ensure
that the Media Guide is positioned
properly; see Section 3.4.
4) The Leveling Cam may be
improperly adjusted; see Section
5.2.1.
5) The label may be longer than the
default value for maximum length.
Check the Media Settings /
Maximum Label Length; see
Section 4.2.2.
6) The Media Sensor may be
obstructed. Check and carefully
remove any obstruction (labels,
paper dust, adhesive, etc).
If media is not moving:
The Head Lift Lever may not be
latched; close and lock it.