Operator`s manual

A-Class 117
6.4 Resetting the Printer
Depending upon the method used, there are three possible printer reset levels:
6.4.1 Soft Reset
To clear the printer of any temporary host settings:
With the printer ‘On’, press and hold the CANCEL Key for approximately four seconds.
6.4.2 Level One Reset
To return the printer to factory default settings and, if saved, to restore the Factory Setting File:
1. Turn ‘Off’ the printer.
2. Press and hold the PAUSE and CANCEL Keys while turning ‘On’ the printer; continue to depress the
keys until the ‘SYSTEM RESET’ message flashes.
 Note: This reset has the same effect as the System Settings / Set Factory Defaults selection in the menu
system. (See Section 4.2 for a listing of the factory default settings and Section 4.2.5 for information
about the Factory Setting File.)
6.4.3 Level Two Reset
To return the printer to factory default settings, and to clear all the calibration and adjustment parameters:
1. Turn ‘Off’ the printer.
2. Press and hold the PAUSE, FEED, and CANCEL Keys while turning ‘On’ the printer; continue to
depress the keys until the ‘SYSTEM RESET’ message flashes.
 Note: After executing a Level 2 Reset, calibration must be performed; see Section 5.1. A listing of the factory
default settings can be found in Section 4.2.