Operator`s manual

122 A-Class
Printing (continued)
Justification: Dependant upon the model’s right hand (RH) or left hand (LH)
designation, where RH is right justified and LH is left justified.
Distance of media edge to
printhead “Dot 1”: All RH models: .070 inch (1.78 mm)
A-4212 LH: .070 inch (1.78 mm)
A-4310 LH: 0
A-4408 LH: .070 inch (1.78 mm)
A-4606 LH: 0
A-6212 LH: 0
A-6310 LH: .054” (1.37 mm)
Printhead Protection: Thermistor sensor.
Flash Memory: 4 MB, or 8 MB (with optional Main Logic Card)
DRAM Memory: 16 MB
Media and Ribbon Requirements
Media Types: Wound-out labels only. Roll-fed, die-cut, notched, reflective
continuous, and fan-fold media. Flat printable side, with no more
than .0007” (.018 mm) protrusions on the opposite side. See
drawing below.
Ribbon Types:
‘Coated Side In’ and ‘Coated Side Out’ types, depending upon the
Ribbon Supply Hub in the printer. Types are NOT
interchangeable.
Core Size –
1.010 inches ± .006 inches (25.6 mm ± .2 mm) inner diameter core;
core not to protrude beyond the ribbon’s edge.
Width Range – Model dependant, where the ribbon width should slightly exceed the
label width (and backing material) being used:
A-4xxx models: 1.0 – 4.65 inches (25.4 – 118.1 mm); and
A-6xxx models: 2.0 – 6.7 inches (51.8 – 170.2 mm).
Maximum Length:
1968 feet (600 meters)