Operator`s manual

A-Class 145
WARNING
Failure to properly configure the jumper settings of the GPIO Port may result in damage to the printer and / or the applicator.
GPIO Port (J2) Pin Functions and Associated Jumper Selections
Pin
#
Signal
Name
Signal
Direction
Active
Setting
Jumper
Placement
Function /
Description
Ground Ground JMP 7 ‘On’ Printer chassis ground is used
1 Ground (Configurable)
Open Open JMP 7 ‘Off’ Ground Return must be supplied
Output +5 VDC JMP 8 ‘On’ Printer +5 VDC is used (.5 amp max.)
2
+5 VDC (Configurable)
Open Open JMP 8 ‘Off’ +5 VDC must be supplied
3 Start Of Print
[5]
Input Programmable
[1]
4 Slew Label
[4]
Input Low
5 Pause Toggle Input Low
6 Reprint
[3]
Input Low
7 +24 VDC (1.0 amp max.) Output +24 VDC
8 Ground Ground Ground
N/A
N/A
9 Ribbon Low Output Programmable
[1]
10 Service Required
[2]
Output Low
11 End Of Print Output Programmable
[1]
12 Media Out Output Low
13 Ribbon Out Output Low
14 Data Ready (DRDY) Output Low
JMP 9:
Pins 1 & 2 = +5 VDC
– OR –
Pins 2 & 3 = +24 VDC
See WARNING message, above.
When inactive, all output pins will be pulled up to the voltage
determined by this jumper setting.
15 Spare Output N/A N/A N/A
[1]
For details see Section 4.2.4.
[2]
Evoked by occurrences listed under ‘Fault Messages’ in Section 6.2.
[3]
Reprints the last label exactly, with no increment or time stamp changes; use it for error conditions. Always keeping this signal LOW will result in non-stop printing.
[4]
Advances media until the signal goes HIGH and, if not in continuous mode, the media will be positioned at the next available media TOF.
[5]
If active with no current print job, “WAITING FOR DATA” is displayed. Specifying a quantity of 9999 while always keeping this signal ‘ON’ will cause non-stop label
printing, except in single label mode (see Imaging Mode, Section 4.2.5), which will cause the printer to stop between labels; see Timing Diagrams, below.