Operator`s manual

A-Class 19
3.2.1 Peel Point Dimension
The following dimensions detail the location of the Peel Bar. (Although this example shows a right hand
model, the left hand model will have the identical dimensions.)
 Note: Integrators switching from the PE printer, the reference dimension for the old Peel Bar location is
included in Appendix C.
3.3 Connecting the Printer
The following procedures detail the data and electrical connections to the printer.
3.3.1 Communications Connections
The standard printer can be interfaced to a host via serial, USB, and parallel connections. The printer will
automatically establish communications through the first port that receives valid data. Once established,
the timeout period must be exceeded (ten seconds at default, see Section 4.2.6) or the printer’s power
must be cycled ‘Off and On’ to change the communication port.
 Note: Depending upon the model, the location of the following communications connections can vary.
Peel Bar