Operator`s manual

A-Class 25
3.3.1.5 DMXrfNet Connections
The DMXrfNet option has several menu-selectable modes, as detailed under ‘NIC ADAPTER’ in Section
4.2.6. Depending upon the method you select to configure the DMXrfNet card, you may need a hard wire
connection. In addition, a hard wire connection is necessary if you plan to use the 10 BaseT port or the
Serial Server in your application.
The drawing below illustrates the available mode-dependant connections to the DMXrfNet Card. For
detailed installation, configuration, and operational instructions, refer to the DMXrfNet Resource Manual,
provided with the option.
Console/Serial Server Connector
Status Indicators
DMXrfNet Card
RJ45 Connector
Network Cable
Serial Console or Serial Printer Cable
Reset/Test Button
Antenna
Status
Indicators
Normal
Conditions
Wireless
This red indicator initially comes ‘On’ and then cycles ‘Off’ when power is applied to
the printer. Thereafter, ‘On’ denotes that a wireless link is established.
ACT/Err This green indicator blinks during network activity.
LNK
This yellow indicator initially comes ‘On’ and then goes Off’ when power is applied
to the printer. Thereafter, ‘On’ denotes that a 10 BaseT Ethernet connection is
established.