Operator`s manual

60 A-Class
System Settings (continued)
Displayed Menu Item Details
LABEL STORE When recalling stored label formats, this setting determines the
command recall level used.
STATE & FIELDS
Recalls the printer state (that is, the heat setting, speed settings, etc)
and the label-formatting commands of the stored label.
FIELDS ONLY
Recalls only the label-formatting commands of the stored label.
MENU LANGUAGE ♦
Selects the language in which the menu system messages and
configuration label are shown. Only languages that are resident will
be shown. See Appendix E for downloading information.
ENGLISH
English
FAULT HANDLING When a fault condition (ribbon out, media out, etc.) is detected, this
setting determines the level of intervention and the disposition of
the label being printed at the time the fault occurred.
LEVEL
Selects the printer’s action, the action required by the operator, and
the label’s reprint status.
STANDARD
Printing stops and a fault message is displayed. After the problem is
corrected, the FEED Key must be pressed to clear the fault. The
label in process is reprinted.
VOID AND RETRY
Depending upon the RETRY COUNT, one of the following actions
when faulted:
• If the Retry Count setting has not been exceeded, ‘VOID’ is
printed on the label in process and reprinting occurs
automatically; or,
• If the Retry Count has been exceeded, printing stops and a fault
message is displayed. After the problem is corrected, the FEED
Key must be pressed to clear the fault. The label in process is
reprinted; or,
• If the CANCEL Key is pressed the operator now has a reprint
option: To allow a reprint, press the ESCAPE Key; or, to cancel
the reprint, press the ENTER Key (and, to cancel the entire batch
by press the ENTER Key again.)
 Notes: 1) If a Linear Scanner is not attached, this menu item will
cause the printer to perform as it does in the Standard fault handling
setting (see above), except that VOID will be printed on the faulted
label. 2) VOID will not be printed when insufficient space exists for the
height of the text (see VOID DISTANCE, below) or if the fault occurred
after the entire label was completed (i.e., when the label reaches its
Present Distance at or above the TOF). 3) The Void Message can be
customized, see the Class Series Programmer’s Manual for
downloading details.
NO REPRINT
Printing stops and a fault message is displayed. After the problem is
corrected, the FEED Key must be pressed to clear the fault. The
label in process is not reprinted.