Operator`s manual

68 A-Class
4.3 Printer Messages
The printer displays several different types of information (if not in Menu or Test Mode):
 Enter and Exit Prompts; see Section 4.2.1
 Alert Prompts and Condition Messages; see Section 4.3.1.
 Application and Boot Loader Updating Messages; see Sections 5.5 and 5.6.
 Fault and Warning Messages; see Section 6.2.
4.3.1 Alert Prompts and Condition Messages
Alert Prompts appear when an action is required of the operator, while Condition Messages are used to
indicate an operational state of the printer.
Prompts and Condition Messages
Displayed Message Description Cause(s)
!CLEARING FAULTS
!
The printer is trying to clear a fault
condition.
The FEED Key was pressed after a
fault.
CALIBRATING
Media calibration is being
performed.
The FEED Key was pressed and
held.
CANCEL REPRINT
ENTER KEY = YES
!
The current label will not be
reprinted if the ENTER Key is
pressed. (Any labels remaining in the
batch will be printed.)
The CANCEL or TEST Key was
pressed during the fault handling
process.
CANCEL BATCH
ENTER KEY = YES
!
The remaining labels in the current
batch will not
be printed if the
ENTER Key is pressed.
The CANCEL or TEST Key was
pressed during a batch job.
DMXNET INITIALIZING!
Normal power-up and soft reset
condition when equipped with the
DMXNet or DMXrfNet option.
The network card is initializing.
Depending upon the programmed
settings, this process can take up to
two minutes.
OFFLINE
The printer is in Menu or Test Mode.
The Menu or Test Key has been
pressed.
PAUSED
The printer is paused.
The PAUSE Key has been pressed
or Paused Mode has been selected.