Operator`s manual

102 I-Class
Dimensional Requirements are listed in the following table:
E
J
I
C
K
A
B
D
H
F
G
Side View
Top View
Media Dimensional Requirements
Designator Description Minimum
[1]
Maximum
[1]
A Label width 1.00 4.65
B Liner width 1.00 4.65
C Gap (or notch) between labels
[3]
.10 –
D Label length
[3]
.25 –
E Media thickness .0025 .010
F Notch opening width .20 .500
G Media edge to sensor aperture distance .20 2.25
H Reflective (black) mark width
[2]
.50 4.65
I Distance between reflective marks
[3]
.50 –
J Reflective mark length
[3]
.10 –
K Label repeat distance
[3]
.35 –
[1]
Units of measure are given in inches and referenced by the direction of label feed.
[2]
The reflective (black) mark must be carbon based, placed on the backside of the stock, and the
reflectance shall be less than 10% at wavelengths of 950 and 640 nm.
[3]
The maximum allowable length of the combined label and gap (or mark) measurement cannot
exceed 99.99 inches.