Operator`s manual
Agency Compliance and Approvals 
C US 
 Listed 
UL60950 Information Technology Equipment 
C22.2 No. 950-M93 
EN60950 
For 230 Volt Operation (Europe):
 Use a cord set, marked “HAR,” consisting of 
a min H05VV-F cord which has a minimum 0.75 square mm diameter 
conductors, provided with an IEC 320 receptacle and a male plug for the 
country of installation rated 6A, 250V 
Für 230 Volt (Europa):
 Benützen Sie ein Kabel, das mit “HAR” markiert ist, 
bestehend mindestens aus einem H05VV-F Kabel, das mindestens 0,75 
Quadratmillimeter Drahtdurchmesser hat; sowie eine IEC320 Steckdose und 
einen für das Land geeigneten Stecker, 6A, 250 Volt. 
As an Energy Star Partner, the manufacturer has determined that this product 
meets the Energy Star guidelines for energy efficiency. 
The manufacturer declares under sole responsibility that this product conforms 
to the following standards or other normative documents: 
EMC: EN 55022 (1993) Class B 
  EN 50024 (1998) 
  EN61000-4-2 (1995), 4kV CD 
  EN61000-4-3 (1996), 3V (80%) AM 
  EN61000-4-4 (1995), 500V Signal Lines /1 kV AC Power Lines 
  EN61000-4-5 (1995), 1 kV 
  EN61000-4-6 (1996), 3V (80%) AM 
  EN61000-4-8 (1994), 1 A/M 
 EN61000-4-11 (1994) 
 EN61000-3-2 (1995) 
 EN61000-3-3 (1995) 
Safety: This product complies with the requirements of IEC 60950. 
Gost-R  
GB4943-2001, GB9254-1998 and GB17635.1-2003 
FCC: This device complies with FCC CFR 47 Part 15 Class A 
 Note: This equipment has been tested and found to comply with the limits for a Class A digital device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against 
harmful interference when the equipment is operated in a commercial environment. This equipment 
generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with 
the instructions in this manual, it may cause harmful interference to radio communications. Operation of 
this equipment in a residential area is likely to cause harmful interference in which case the user will be 
required to correct the interference at his expense. 










