Operator`s manual

30 I-Class
Printer Options (continued)
Menu Item Details
BARCODE COUNT
Specifies a number of bar codes per label and
generates a fault when the number present is incorrect,
where:
00 (0 - 99) Sets the number of bar codes to count, where 00 (Auto
Mode) allows a variable number.
 Note: If bar codes are bitmaps, enter the minimum
number to be read on each label (check your
software application if questioning the bar
code generation method).
MIN READABLE HEIGHT
Ensures bar code integrity by setting a minimum
distance for identical decodes, where:
DISABLED
Uses REDUNDANCY LEVEL to ensure bar code integrity.
1/16 – ½ in
(1.5–12.5mm)
Sets a read distance requirement to pass the bar code
(e.g., ¼ requires .25 inches to be readable).
 Note: This distance should not exceed 50% of the
measured bar code height.
REDUNDANCY LEVEL
Ensures bar code integrity by specifying a consecutive
number of identical decodes, where:
READ BARCODE 3X Sets a valid read count requirement (1X – 6X) to pass
the bar code (e.g., 3X must return three identical
decodes).
 Note: High redundancy rates and fast print speeds
may cause erroneous read failures when
scanning small or multiple bar codes.
AUTO
Uses MIN READABLE HEIGHT to ensure bar code
integrity.
IGNORE NO DATA Allows an override of data verification, where:
DISABLED
Checks for correct bar code data in the bar code(s).
ENABLED Ignores the data present in the bar code(s).
SET DEFAULTS
Restores the scanner settings to the default values,
where:
SET FACTORY DEFAULT?
CANCEL KEY = YES
Restores the defaults, or press the ESC Key to keep the
current configuration.