Operator`s manual

I-Class 43
System Settings (continued)
Menu Item Details
FAULT HANDLING Determines the label disposition and user action if a
fault occurs, where:
LEVEL
Sets the printer response upon declaration of a fault,
where:
STANDARD Stops printing and declares a fault. Then, following
correction of the problem, the FEED Key must be
pressed to clear the fault and reprint the label in
process.
VOID AND RETRY
Actions depend upon the RETRY COUNT:
• If the count has not been exceeded, VOID is printed
on the failed label and reprinting automatically
occurs;
• If the count has been exceeded, printing stops and a
fault message is displayed. Then, following correction
of the problem, the FEED Key must be pressed to
clear the fault and reprint the label in process; or,
• If the CANCEL Key is pressed, reprinting is optional:
press NO to reprint; or, press YES to cancel the
reprint (and press YES again to cancel the batch.)
 Note: Linear Scanner or RFID required.
DELAYED SCAN FAULT
Increases throughput when bar codes reside near the
trailing edge of the label (in the direction of FEED).
 Notes: (1) Linear Scanner or RFID required.
(2) If unreadable, the fault will occur after
the next label prints;
(3) The label immediately following a
faulted label is not scanned for errors; and,
(4) VOID AND RETRY and REPRINT are
automatically disabled; the job can only be
cancelled.
VOID RETRY & CONT. VOID is printed on a faulted label, with reprint
attempts occurring automatically, until the RETRY
COUNT has been exceeded and then that label will be
skipped (discarded) and printing will continue to the
next label in queue.
 Note: Linear Scanner or RFID required.
NO REPRINT
Printing stops and a fault message is displayed.
Following correction of the problem, the FEED Key
must be pressed to clear the fault.