Operator`s manual

I-Class 47
Communications (continued)
Menu Item Details
WLAN ADHOC?
CANCEL KEY = YES
Restores the WiFi defaults and initiates infrastructure
mode with an SSID of “Any.” All existing access point
associations will be deleted then established with the
closest available. (Useful when moving the printer to a
geographically distant location.)
 Note: Press the ESC Key to exit the menu item
without changing the current settings.
SET FACTORY DEFAULTS
Returns the factory-programmed values, where:
SET DEFAULTS?
CANCEL KEY = YES
Restores the default settings.
 Note: Press the ESC Key to exit the menu item
without changing the current settings.
WLAN
Controls the communications settings for the optional
DMXrfNetII Card, where:
MODE Selects between Wired or WiFi operation, where:
ENABLED
Enables the WiFi interface.
DISABLED Enables the Wired interface.
BSS ADDRESS Specifies the WiFi bridge module’s static IP address.
 Note: If DHCP is ENABLED, this parameter will be
ignored.
 192.168.010.001 Is the address in standard octet format.
SIGNAL READINGS Displays the signal and noise ratios for the WLAN.
IP ADDRESS
Specifies the static IP Address; where:
192.168.010.026 Is the address in standard octet format.
SUBNET MASK
Specifies the static Subnet Mask Address, where:
255.255.255.000 Is the address in standard octet format.
GATEWAY
Specifies the network Gateway Address, where:
192.168.010.026 Is the address in standard octet format.