Operator`s manual

I-Class 63
Standard Calibration (continued)
Step Action Displayed Message Comment
7
Proceed according to your
media:
Die-cut – remove a label
from the backing
material then place the
backing in the sensor.
Adjust the Sensor Eye
Mark over the center of
the backing.
Notched – load media in
the printer then adjust
the Sensor Eye Mark
over the center of the
notch.
Reflective – load media
in the printer (black
mark facedown) then
adjust the Sensor Eye
Mark over the center of
the black mark.
Continuous – go to Step
8.
Press any key to continue.
SCAN BACKING
PRESS ANY KEY <yyy>


Or, for reflective media:


SCAN MARK
PRESS ANY KEY <yyy>

See Section 3.3 for
sensor positioning
details.
This sets the backing,
gap, or mark value where
“yyy” is the current
sensor reading.
 Note: Never position
the sensor over a
perforation when
sampling.
 Note: Do not move the Media Sensor after it has been positioned.
Step Action Displayed Message Comment
8
Position the media (and
backing, if any) under the
sensor then press any key
to continue.
SCAN PAPER
PRESS ANY KEY <yyy>

This sets the paper value,
where “yyy” is the
current sensor reading.
 Note: If using
preprinted media, ensure
the label area under the
Sensor Eye Mark is free
of text, graphics, or
borders.