Instructions

UM-0085-B09 DT80 Range User Manual Page 129
RG
Figure 25: Schedule configuration
Schedule Trigger
By default, the configuration builder sets a new schedule to a 5 second trigger. To change this time, simply alter the
indicated number and/or time units.To define a daily trigger at a particular time of day, select the Daily at option.
To define other types of schedule trigger (e.g. event triggered, manual trigger), click on Advanced Triggering, which will
cause more controls to appear. Use the Trigger control to select the type of trigger (see Types of Schedules (P51)), then
set any further details that may be required. For example, the following settings will trigger the schedule when a falling
edge is detected on digital input 1D or 2D:
Figure 26: Schedule configuration – advanced trigger
Schedule Conditions
The Conditions area is used to define the schedule "while" condition (see Trigger While (P55)) – where, for example, a
schedule will only trigger while a certain digital input is active. By default, there is no while condition.
Storage Settings
To set the schedule storage parameters, click on the Storage tab. This allows you to define various schedule options
such as store file size and whether you want old data to be overwritten by new. See Logging Data (P94) for more details.
Note: The Enable Logging control selects the initial logging state (on or off) for the schedule. Regardless of the setting, space will still
be allocated for data storage, as specified in the data and alarms Storage Size controls. If you do not want to allocate any space for
logging data then set the Storage Size controls to 0.