Instructions

UM-0085-B09 DT80 Range User Manual Page 258
RG
• Disable anonymous FTP login:
PROFILE FTP_SERVER ALLOW_ANONYMOUS=NO
• Change the FTP username and password
PROFILE FTP_SERVER USER=paranoia
PROFILE FTP_SERVER PASSWORD=Cant89203432reMemBer9909283thIS
• Set up the DT80 on a private LAN behind a NAT router. You will need to configure the router to forward traffic to
the required servers' ports to the DT80 (see DT80 on Private Network (P238)).
• Disable any pages that are not required in the dEX web interface, using the Web Interface Configuration Tool
(see Customising the Web Interface (P160)).
• Disable the dEX Configuration Builder by renaming the "jango" folder, which will make it disappear from the
logger home page, e.g.
RENAME \www\jango \www\secret_builder
•
Disable the Web Interface Configuration Tool by renaming the "needa" folder, which will make it disappear from
the logger home page, e.g.
RENAME \www\needa \www\secret_customise
• If you connect to the DT80 using PPP over a dial-up modem then configure the host port for PPP only:
PROFILE HOST_PORT FUNCTION=PPP
which means that incoming connections will be rejected if the correct PPP username and password is not
specified.
• If you connect to the DT80 using PPP over a dial-up modem then change the default PPP username and
password:
PROFILE PPP USER=fear
PROFILE PPP PASSWORD=Cant89203432reMemBer9909283thIS222eithER
Note: in the dEX configuration builder, FTP and PPP share the same username and password.
dEX Security
Enabling Security
You can enable an optional security on the Logger that is based on user rights. Once security is enabled it can only be
turned off by a user with administrator rights.
The command to turn on is:
PROFILE AUTHENTICATION ENABLED=YES
Once the authentication is enabled the user session will expire after inactivity for certain period.The session timeout
period is defined in
PROFILE PARAMETER P14 (P264) and the default value is 600 seconds.
User Access Limitation
If there is a logged user in dEX, they must log out (use the logout button/ session time out) or no other user will be able
to log in. The same condition happen in command terminal connection, which user should send
SIGNOFF command to
end the session gracefully.
User Roles and Rights
User Role
Command Line
Rights
No Access
NA
View real time data on the command window
Data Supervisor
DSV
Unload data, view logger status, download data, delete data
Config User
CONF
Unload data, view logger status, download data, delete data, control
current job, configure the logger and load new jobs
Administrator
ADM
Unload data, view logger status, download data, delete data, control
current job, configure the logger and load new jobs.