User`s manual

DT-6X60 User's Manual - Platform (Build 2.0)

DFARS 252.227-7013 or subparagraphs (c)(1) and (2) of the Commercial HARDWARE Software-

Restricted Rights at 48 CFR 52.227-19, as applicable. Manufacturer is Datatek Applications, Inc.,

379 Campus Drive, Suite 100, Somerset, NJ 08873.

If you acquired the SOFTWARE in the United States of America, this Software License are

governed by the laws of the State of New Jersey, excluding its choice of laws provisions. If you

acquired the SOFTWARE outside the United States of America, local law may apply. This

LICENSE constitutes the entire understanding and agreement between you and the Manufacturer

in relation to the SOFTWARE and supercedes any and all prior or other communications,

statements, documents, agreements or other information between the parties with respect to the

subject matter hereof

15 L

IMITATION OF

IABILITY

To the maximum extent permitted by applicable law, in no event shall Manufacturer or its

suppliers be liable for any damages whatsoever (including without limitation, special,

incidental, consequential, or indirect damages for personal injury, loss of business profits,

business interruption, loss of business information, or any other pecuniary loss) arising out

of the use of or inability to use this product, even if Manufacturer has been advised of the

possibility of such damages. In any case, Manufacturer's and its suppliers' entire liability under

any provision of this License shall be limited to the amount actually paid by you for the

SOFTWARE and/or the HARDWARE. Because some states/jurisdictions do not allow the

exclusion or limitation of liability for consequential or incidental damages, the above limitation may

not apply to you.

Printed in USA

06/07/07

Datatek Applications Inc. 68