User`s manual

DT-6061 User's Manual - Platform (Build 16.0)
11/12/04 Datatek Applications Inc. 57
15 APPENDIX E: DT-6061 SPECIFICATIONS
Note: Shielded cables must be used in order to maintain compliance with EMC
requirements.
15.1 CON (CONSOLE)
A standard interface that uses binary data interchange between DTE and DCE. The RS-232C
interface uses an RJ45 connector and operates at 9600 bits per second (bps).
15.2 RS-232/V.35
15.2.1 RS-232C
A standard interface that uses binary data interchange between DTE and DCE. The RS232-C
interface uses a 25-pin (DB25) connector and up to 21 signal leads, and operates at data rates
from 75 to 19200 bits per second (bps).
15.2.2 V.35
A standard interface used for interface and trunk modules. The V.35 interface uses a 34-pin
connector and operates at data rates up to 2.048Mbps.
15.3 10-BASE-T LAN
Eight-pin, 10BaseT modular connector for a 10 Mbps baseband CSMA/CD local area network.
15.4 DSU
This interface uses an industry standard RJ48C connector. The interface may be used for T1
(1.544 MHz) or E1 (2.048 MHz)
15.5 PHYSICAL DIMENSIONS
DT-6061: L= 16.9 x W=8.77 x D=1.72
15.6 ENVIRONMENTAL OPERATING RANGE
Operating Temperature: 5° to 40°C (41°F to 104°F)
Operating Humidity: 5% to 85%
Altitude: From 60M (197) below sea level to 1800 m
(5905 ft.) above sea level
15.7 POWER REQUIREMENTS
DT-6061 Operating Voltage: 5V @ 800 mA Nominal
Stand-alone AC to DC power supply: 115V @ 48mA Nominal
115V @ 90 mA Maximum
Stand-alone DC power supply: 48V @ 104 mA Nominal
48V @ 195 mA Maximum
Rack-mount DC (six units): 48V @ 624 mA Nominal
48V @ 1.17 A Maximum