Instruction manual

37
Mode selects and use
The default mode for the SE-800, and the one you will use most often, is
Video.
In Video only mode (Video LED is lit), the T-Bar operates as expected and
as described everywhere in this manual.
In Video + Audio mode (Both LED are lit), the T-Bar switches Video and
the Audio between selected sources.
In Audio only mode (Audio LED is lit), The T-Bar switches Audio volume
high/low of the selected source
In GPI mode, transitions and effects are played by the trigger (see below).
When in GPI mode, pressing the PLAY button in this section has the same effect as using the GPI trigger.
External trigger using GPI
When you plug in a GPI trigger device to the rear panel GPI input, and the Mode is set to GPI, pressing the
trigger plays sequentially (one at each trigger) through all the presets stored in all the preset Banks.
List of transitions and parameters
(suitable for photocopying)
The numbers at left are the ones you select from the keypad.
Zoom (works in conjunction with Border controls):
1: Zoom off to upper left
2: Zoom on from upper left
3: Zoom off to upper right
4: Zoom on from upper right